|
|
Post by davidross on May 8, 2013 21:09:32 GMT -5
Are the top plates (red metal with rubber overlay) on the ddrum 4 cymbal and hi-hat triggers identical and interchangeable? Can those plates be removed easily with the 2 bolts on the back edge?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 13, 2013 13:49:26 GMT -5
Are the top plates (red metal with rubber overlay) on the ddrum 4 cymbal and hi-hat triggers identical and interchangeable? Well, the top plate of the hihat has a larger hole than the cymbals, but other than that, yes they are identical. There is doublesided adhesive tape plus a sheet of rubber inbetween the plates. (And the piezo trigger of course) Can those plates be removed easily with the 2 bolts on the back edge? The bolts will just remove the black (or silver) cast part from the two plates. You will have to pry the plates apart using a wide screwdriver or the like. It's easy to make the plates uneven during the process. Here's another thread where I mentioned this: unofficially-ddrum.proboards.com/index.cgi?action=display&board=introduction&thread=231&page=1And here are photos of a cast cymbal that I repaired, posted in that thread: www.mediafire.com/?833ofdw09bwbcj0 |
|
