olle
New Member
Posts: 5
|
Post by olle on Jan 23, 2012 16:56:14 GMT -5
hello, a friend of my bought a ddrum 4 module and today i tried to install the module on a acoustic set with ddrum pro triggers when i scrolled to the trigger inputs i saw there where missing some inputs the nh1 2 3 and hht my question is is it possible to restore these inputs somehow because without these acoustic triggering sucks greets ,Olle
|
|
|
Post by kyrrinstoch on Jan 24, 2012 8:40:49 GMT -5
what version of the firmware is the unit running? Check the display when it first powers up. It'll show the firmware version for a moment, then go into pallette mode (pal).
|
|
olle
New Member
Posts: 5
|
Post by olle on Jan 24, 2012 8:58:37 GMT -5
Its running 1.40 the same as mine
|
|
|
Post by sam(otacon28) on Jan 24, 2012 10:28:54 GMT -5
|
|
olle
New Member
Posts: 5
|
Post by olle on Jan 24, 2012 13:02:24 GMT -5
The module has Firmware 1.32 is it possible with this firmware to have the inputs nh1 2 3 than i can reset the module
|
|
|
Post by sam(otacon28) on Jan 24, 2012 17:36:08 GMT -5
The module has Firmware 1.32 is it possible with this firmware to have the inputs nh1 2 3 than i can reset the module I don't believe that the nh1 - nh3 were setting that were on the 1.32 firmware being that they are more for mesh head settings . There should be AC1 , AC2 , & AC3 selections on there though and those are for use with acoustic drums with triggers on them . I believe Clavia didn't release the " nh " settings until the SE modules and SE version firmware chipsets . If the module is originally a 1.32 module it can be upgraded to 1.50 by switching out the firmware chipset . sam(otacon28)
|
|