jason
New Member
Posts: 9
|
Post by jason on Aug 7, 2023 21:36:26 GMT -5
Hello all,
I have a 1999 Ddrum4 module with pads, hi hat and cymbals. It had the 1.32 chip so I upgraded to the 1.5. Put the chip in and everything was great. I cleared the memory and loaded it up with the Se factory sounds using the uno midi. Everything went fine. I plugged everything back in and started it up and non of the triggers would respond. The channel triggers respond as the should meaning they make the led bar raise in response but no sound.
So to sum up, no pad or cymbal will trigger the led bar response but the channel triggers will. Neither the pads or the channel triggers will make a sound.
I have tried the factory reset, erasing and reloading the samples. Checked the sensitivity knobs, checked the threshold, checked the cables, checked the headphones. No change.
I'm at my wits end. I could replace all the inputs but I can't believe they could all go out at once.
I hope i am just doing something stupid.
PLEASE HELP!!!
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 8, 2023 2:02:56 GMT -5
Maybe you accidentally set Local Off? Alternatively output routing has been set to outputs other than the one you have plugged in. I suggest connecting MIDI out to a laptop where you have MIDI monitor installed. This way you can see that dd4 is atleast transmitting MIDI. plugins4free.com/search?term=midi%20monitor
|
|
jason
New Member
Posts: 9
|
Post by jason on Aug 8, 2023 21:24:54 GMT -5
Thank you very much for responding. I will look at that and get back.
I am so thankful for this board!!!
|
|